APP下载

诱导式风管内流体特性的数值模拟研究

2016-01-26苏飞,魏兵

电力科学与工程 2015年8期

苏 飞,魏 兵

(华北电力大学 能源动力与机械工程学院,河北保定071003)

诱导式风管内流体特性的数值模拟研究

苏飞,魏兵

(华北电力大学 能源动力与机械工程学院,河北保定071003)

摘要:低温送风诱导式缩放风管具有结构简单、造价低廉、节省能耗、噪声低、维修工作量小和能利用普通风口等优点,但不易达到较高的诱导比。运用CFD软件对风管内部流体特性进行模拟,通过云图进行压力分析,并在云图静压较低处对应地设置二次风口。计算各种情况下诱导风管的诱导比,通过诱导比计算值的对比,确定出二次风口的最佳位置,设计出诱导式缩放风管的吸收段。

关键词:诱导式风管;吸收段;二次风口;数值模拟

中图分类号:TU831.3

文献标识码:A

DOI:10.3969/j.issn.1672-0792.2015.08.010

收稿日期:2015-06-19。

基金项目:国家自然科学基金青年基金(51408820)。

作者简介:苏飞(1989-),男,硕士研究生,研究方向为建筑节能技术,E-mail:sfhvac305@163.com。

Abstract:Considering its simple structure, low cost, energy savings, little noise, small amount of maintenance and adaptability to normal vent, cold air distribution induction scaling duct is spoken highly of. But it is not easy to reach a high induction ratio. In this paper, CFD software was adopted to simulate internal fluid properties in the induction ducts. Then secondary air inlets were located in the position with the lowest static pressure after the analysis of the contours. Finally, the induction ratios for different ducts were calculated. After comparing induction ratios, the optimal location of secondary air inlet is determined and the absorption section is designed.

Keywords:induction duct; absorption section; secondary air inlet; numerical simulation

0引言

低温送风空调系统的送风温度为4~10 ℃,比常温空调系统的送风温度12~16 ℃低[1,2]。采用低温送风技术能够降低空调系统的能耗,也能节省初投资和运行费用[3~7],经济效益明显。低温送风的末端装置对空调系统的成功运行起着至关重要的作用[8~10]。在低温送风的各种形式中[11~13],不带风机的诱导式风管以其结构简单、造价低廉、节省能耗、噪声低、维修工作量小和能利用普通风口等优点而备受推崇,但不易达到较高的诱导比[14]。

诱导比是衡量诱导式风管性能的关键参数[15],提高诱导比成为设计诱导式风管的关键。当收缩段几何造型固定时,吸收段二次风口(诱导风口)的位置对诱导比有很大的影响。……

登录APP查看全文