基于散射参数测量的单口无源设备宽频建模
2016-01-26郑陈达孙海峰
郑陈达,孙海峰
(1.国网福建省电力有限公司 检修分公司,福建福州350000; 2.华北电力大学 电气与电子工程学院,河北保定071003)
基于散射参数测量的单口无源设备宽频建模
郑陈达1,孙海峰2
(1.国网福建省电力有限公司 检修分公司,福建福州350000; 2.华北电力大学 电气与电子工程学院,河北保定071003)
摘要:单口无源类设备如电抗器、电容器等在电力系统中有着广泛的应用,发展单口设备的宽频等效电路建模方法,是研究电力系统电磁兼容以及过电压分析等问题的基础。采用一种快速等效电路建模方法,基于设备端口散射参数的测量,从设备的宽频阻抗特性出发得到设备的宽频等效电路模型,并引入数学优化算法进一步对模型参数加以优化。最后,在100 Hz~30 MHz的频率范围内建立实际电抗器宽频电路模型,并比较模型与实际设备在频域以及时域的相应特性,验证了该方法的可行性。
关键词:散射参数;宽频模型;模拟退火算法;电抗器
中图分类号:TM73
文献标识码:A
DOI:10.3969/j.issn.1672-0792.2015.08.002
收稿日期:2015-06-02。
基金项目:国家自然科学基金(51207054);中央高校基本科研业务费科研专项资金(13MS75)。
作者简介:郑陈达(1989-),男,硕士研究生,研究方向为电力系统过电压防护,E-mail:dariotzen@hotmail.com。
Abstract:Passive single-port equipment such as reactor and capacitor has a wide application in the power system,so development of single-port equipment wide-band equivalent circuit modeling method provides foundation for researching the power system electromagnetic compatibility and the problem of over voltage analysis.In this paper, a fast equivalent circuit modeling method was used and wide-band equivalent circuit was established basing on the scattering parameter measurement. In addition parameters was optimized through mathematical optimization algorithm.Finally,circuit model of a reactor was established in the frequency range of 100 Hz~30 MHz, comparing the model with the actual equipment in the frequency domain and the time domain. Therefore, the result may verify the efficiency of the method.
Keywords:scattering parameters; wide-band modeling; simulated annealing algorithm; reactor

0引言
高压直流输电尤其是柔性直流输电技术凭借其独有的优势逐渐成为现代电力系统中重要的组成部分。如同电力系统中其他设备一样,直流输电换流站内设备面临由系统的操作、故障及雷击等原因产生的过电压冲击[1]。站内设备的过电压分布以及过电压水平不仅影响到设备的设计和选择,还关系到换流站整体能否可靠运行[2]。……
