APP下载

障碍物对容器出口处颗粒物堵塞概率影响分析

2021-07-28周益娴廖凯关艺璞

科技创新导报 2021年9期
关键词:堵塞

周益娴 廖凯 关艺璞

DOI:10.16660/j.cnki.1674-098x.2102-5640-4756

摘  要:容器出口处的堵塞是颗粒物质研究中的一个热点和难点问题。实验证实,如果在容器出口处放置障碍物,會大幅度降低颗粒物堵塞概率,但其背后物理机理仍旧不清晰。通过实验获得颗粒物压力等信息较为困难,本文利用离散元软件研究障碍物中心距离出口高度及其几何尺寸对平底筒仓堵塞概率的影响。模拟结果表明当障碍物中心距离出口高度取出口尺寸的两倍时,能明显降低堵塞概率,随着高度升高,堵塞概率趋近于无障碍物时的大小,而障碍物尺寸对堵塞概率无明显影响。为研究该问题的背后物理因素,求解了不同障碍物中心距离出口高度下出口处颗粒物体积分数、竖直方向速度以及接触压强的平均值,结果表明,出口处接触压强是影响堵塞概率的首要因素。该研究将为高温气冷堆出口处设计以及门后立柱等交通流问题提供理论依据。

关键词:颗粒物质  球流  堵塞  接触压强

中图分类号:O39                              文献标识码:A                    文章编号:1674-098X(2021)03(c)-0001-4

Analysis of the Influence of Obstacle on the Clogging Probability of Particle Blockage at the Outlet of Container

ZHOU Yixian1  LIAO Kai2*  GUAN Yipu1

(1, Beijing Key Laboratory of Passive Safety Technology for Nuclear Energy, North China Electric Power University, Beijing, 102206 China; 2, China Urban Sustainable Transportation Research Center, China Academy of Transportation Sciences, Beijing, 100029 China)

Abstract: Clogging phenomenon is one of the most fundamental subjects in the research of granular media which has attracted significant attention. It has been shown experimentally that the presence of an obstacle above the orifice can significantly reduce the clogging probability of particles discharging from a silo. However, the underlying physical mechanism still remains unclear. As it is difficult to obtain the information of contact pressure from experiment, in this work, we study the effect of the obstacle position and size on the clogging phenomenon of a flat-bottomed silo by using discrete particle simulation. The simulation shows that when the distance between the obstacle center and bottom of the silo is twice the orifice size, the clogging probability can be significantly reduced. As the obstacle position value increases, the clogging probability approaches the value obtained in the case without obstacle. The size of the obstacle has no significant effect on the clogging probability. To understand the underlying physical mechanism, we calculate the following parameters: the statistical averaging of the volume fraction, vertical velocity and contact pressure of particles near the aperture during discharge. We find that, among all relevant variables, the contact pressure of particles is the main cause of the variation of clogging probability. This study provides a theoretical basis for the design of the exit of the high-temperature gas-cooled reactor and for the research on traffic flow problems such as the column behind the door.

Key Words: Particulate matter; Ballflow; Clogging; Contact pressure

容器出口处的堵塞是颗粒物质研究中的一个热点和难点问题。该问题在工业中的颗粒流、交通流(如人群紧急情况逃生)以及生物医学等方面都有广泛的应用。在高温气冷堆反应堆堆芯区,也可能存在着燃料球在输运过程中的堵塞问题,在底部出口部分可能形成一个拱形,一旦发生堵塞,则换料停止,可能引发严重的后果。近来,人们通过实验发现,除改变容器以及颗粒物本身几何和材料特性之外,还可通过在出口处放置障碍物来降低堵塞概率,但其背后物理机理仍旧不清晰。……

登录APP查看全文

猜你喜欢

堵塞
电厂石灰乳加药装置堵塞出力不足原因分析及处理
硫磺装置常见堵塞部位及其预防
火电厂煤仓清堵系统的应用研究
电站锅炉回转式空预器堵塞分析与研究
酸性气火炬筒结晶堵塞的分析与改进探讨
陡河电厂除雾器堵塞分析及改造的技术探讨
集输脱水站管道常见问题及对策
集输脱水站管道常见问题及对策
SCR脱硝热解炉结垢原因分析及解决方法
脱销系统运行与防止空预器堵塞