固定化溶菌酶的缓蚀机理及性能
2017-10-11姜国飞刘芳李佳蔓王洪喜赵朝成王永强
姜国飞,刘芳,李佳蔓,王洪喜,赵朝成,王永强
固定化溶菌酶的缓蚀机理及性能
姜国飞,刘芳,李佳蔓,王洪喜,赵朝成,王永强
(中国石油大学(华东)化学工程学院,青岛266580)
采用物理吸附方法将溶菌酶固定在MCM-41介孔分子筛上,并与化学缓蚀剂[氨基三亚甲基膦酸(ATMP)与聚天冬氨酸(PASP)]复配用作循环冷却水缓蚀剂。利用电化学法分析复配缓蚀剂的缓蚀机理,并用失重法所测得的复配缓蚀剂缓蚀性能为指标优化复配条件。结果表明:复配缓蚀剂为混合型缓蚀剂,可以同时抑制腐蚀过程的阴极反应与阳极反应,最佳复配方案为固定化溶菌酶投加量0.7 g/L、ATMP质量浓度10 mg/L、PASP质量浓度20 mg/L,缓蚀率可达88.55%,循环冷却水对碳钢腐蚀速率降至0.017 3 mm/a,作用时间为11~13 d。
溶菌酶;固定化;缓蚀剂;缓蚀率;作用时间
Abstract:Lysozyme was immobilized on MCM-41 mesoporous molecular sieve by physical adsorption method,and then compounded with chemical inhibitors amino trimethylene phosphonic acid(ATMP)and sodium of polyaspartic acid(PASP)to act as the circulating cooling water inhibitor.Electrochemical methods were used to analyze the inhibition mechanism of the compound inhibitor,and the method of weight loss of was used to analyze the inhibition performance of the compound inhibitor which would be the index of the optimized compound condition.The results showed that the compound inhibitor was a mixed inhibitor,which could inhibit the cathodic reaction and the anodic reaction in the corrosion process at the same time.The optimal compound scheme was as follows,when the adding amount of immobilize lysozyme was 0.7 g/L,ATMP was 10 mg/L and PASP was 20 mg/L,theinhibition rate could be up to 88.55%,the corrosion rate of carbon steel in circulating cooling water would decrease to 0.0173 mm/a,and the action time could be up to 11-13 days.
Key words:lysozyme;immobilization;corrosion inhibitor;inhibition rate;action time
循环冷却水是指在生产过程中,通过直接或间接接触来交换介质热量并经冷却塔凉水后,可以循环使用的冷却水。在石油化工、冶金、钢铁、电力等行业中,循环冷却水的使用量可占到工业用水的85%~92%[1]。在使用循环冷却水时,由于其含有一定的盐分,会对设备造成不同程度的腐蚀,加重工业运行成本。
为了解决工业循环冷却水造成的设备腐蚀问题,常用的防护方法是向循环冷却水中投加化学缓蚀剂[2],化学缓蚀剂虽然缓蚀性能较强,但却不能够重复利用,且在使用过程中易造成二次污染。段成龙等[3]研究发现溶菌酶具有缓蚀性能,并且在使用过程中不会产生二次污染,但缓蚀性能相对化学缓蚀剂略低,稳定性易受环境条件如温度、p H等因素影响,且价格较高。……
