660 MW超超临界机组高负荷主蒸汽温度偏低原因分析
2017-07-14江波熊钟史萌萌
江波 熊钟 史萌萌


摘要: 对某电厂HG2035/26.15YM3型超超临界参数直流锅炉主蒸汽温度偏低进行了分析,找出了该厂加负荷过程主蒸汽温度低的原因.由于加负荷过程中给水泵汽轮机再循环门存在较大内漏,使给水流量达不到设计值,导致INFIT协调系统水煤质量比失调,过热度大幅波动,最终导致主蒸汽温度偏低.根据现场具体运行情况,分别制定了调整给水泵汽轮机再循环门行程、高负荷控制负荷增加速度、根据给水泵汽轮机转速调整好过热度等三项改进措施.通过运行人员认真监视和调整,未再出现主蒸汽温度偏低的现象,保证了机组的安全稳定运行.研究为同类机组提供了参考.
关键词:
超超临界; 主蒸汽; 水煤质量比; 过热度
中图分类号: TK 222文献标志码: A
Causes Analysis of Low Steam Temperature for 660 MW Ultrasupercritical Unit with High Load
JIANG Bo1, XIONG Zhong1, SHI Mengmeng2
(1.SPIC Jiangxi Electric Power Co., Ltd. Jingdezhen Power Plant, Jingdezhen 333000, China;
2.Jiangxi Jingdezhen Power Supply Company, Jingdezhen 333000, China)
Abstract:
The causes of low steam temperature for HG2035/26.15YM3 type ultrasupercritical oncethrough boiler in a power plant were analyzed.The reasons of low steam temperature in the adding load course were found out.In this course,there existed large internal leakage in the recirculation valve of feed water pump.The designed value of the water flow could not be reached.The ratio of coal to water controlled by INFIT was imbalanced.The degree of superheat fluctuated wildly.The main steam temperature was low at the end.According to the run on site,the improvements were made including stroke adjustment of feed water pump recirculation valve,rate of load increasing under high load condition,and degree of superheat adjustment according to the rotate speed of feed water pump.According to these improvements,low steam temperature didnt occur again,which could make the unit run steadily and safely.The research could provide references for the same kind of unit.
Keywords:
ultrasupercritical; main steam; coalwater ratio; degree of superheat
近年来,随着可再生能源的快速发展,火力发电量占发电总量比例呈下降趋势[1],但火电厂仍然是我国电能供应的主力军[2].保证火电厂的安全稳定高效运行是每个电厂首要目标[3].在火电厂主要参数中,主蒸汽温度直接影响机组的安全与经济,因此保证机组主蒸汽温度稳定是有必要的[4].本文对某超超临界机组高负荷主蒸汽温度低于设计值进行了诊断分析,并提出了解决方案.
1锅炉概况
国家电投集团江西电力有限公司景德镇发电厂(简称景电)二期擴建工程2×660 MW机组2号锅炉采用哈尔滨锅炉厂有限责任公司设计和制造的HG 2035/26.15YM3型超超临界参数直流炉,其为单炉膛、一次再热、平衡通风、露天布置、固态排渣、全钢构架、墙式切圆燃烧、全悬吊结构Π型锅炉.该锅炉变压运行,采用定滑或定滑定的运行方式,带基本负荷并参与调峰.锅炉主要设计参数如表1所示,表中:BMCR为最大连续蒸发量工况;……
