生活污水处理厂强化脱氮除磷工艺改造及效果分析
2017-07-13孔繁德李立欣张连福
孔繁德 李立欣 张连福


摘要 黑龙江科技大学污水处理厂在生物氧化处理工艺基础上,结合该厂的实际运行情况进行了升级改造,改造后工艺为A2/O法,该工艺将
固定生长的微生物引入曝气池内,形成了非固定化的活性污泥,建立了与附着态(生物膜)微生物共生的生化反应池。该系统既具有生物膜法运行稳定、容积负荷较高等优点,又能充分发挥活性污泥法出水水质好、脱氮除磷效果好等优势。
关键词 生活污水处理厂;脱氮除磷;升级改造
中图分类号 X52 文献标识码 A 文章编号 0517-6611(2017)02-0053-02
Abstract Based on biological oxidation treatment process for municipal sewage treatment plant of Heilongjiang University of Science and Technology,combining with the actual operation,the plant was upgraded and transformed.The upgraded and transformed process was A2/O.The immobilized activated sludge was formed by the introduction of fix microorganism in the aeration pool,and the attached biofilm was established in the biochemical reaction tank.The system was running stably,had the advantages of biofilm and activated sludge with efficient nitrogen and phosphorus removal.
Key words Municipal sewage treatment plant;Nitrogen and phosphorus removal;Upgrading and reconstruction
《全国城镇污水处理及再生利用设施“十一五”建设规划》规定:对排入封闭和半开放水域、现已富养化或接近富养化程度的水域,区域内污水处理厂应选用具有强化脱氮除磷功能的污水处理工艺[1]。黑龙江科技大学污水处理(中水)厂于2006年8月建成并投入运行,处理规模4 000 m3/d,部分出水作为中水回用。设计出水按《城市污水再生利用 城市杂用水水质》(GB/T 18920—2002)[2]规定:COD≤60 mg/L,BOD≤20 mg/L,SS≤20 mg/L;但对氮、磷排放的含量并未作出规定与要求。近年来,在黑龙江科技大学发展的同时,污水厂进水由设计的4 000 m3/d到实际处理近6 000 m3/d,现工艺出水水质超标现象频发。另外,随着人民生活水平的提高,对环境保护的要求也不断提高,尤其是对城市污水处理厂出水水质中氮、
磷含量的要求越来越严格。因此,黑龙江科技大学污水处理厂于2016年启动了改造工程,在原有生物接触氧化工艺基础上进行了改造,经调试,处理水量目前可达6 000 m3/d,根据《城镇污水處理厂污染物排放标准》(GB 18918—2002)[3]的一级 A 标准要求,出水水质稳定达标排放。……
