高速铁路斜井下穿石油管道施工技术研究
2017-07-08张世文
张世文
摘要: 通过对本课题的研究,明确了控制爆破在泥岩砂岩地层和浅埋地层斜井施工技术,避免了爆破设计的不合理,根据实际爆破参数的验证,总结出了适合本工程泥岩砂岩地层的爆破参数计算方法及相关参数,对地震波允许参数的设定提供了参考。针对泥岩砂岩地层和浅埋地层开挖施工常见问题进行分析,提出合理的解决措施,帮助项目提前做好了合理施工方案,避免石油管道泄漏爆炸事故的发生,从而大大降低了工程施工成本和对当地环境不利的影响。
Abstract: Based on the research of this subject, it is clear that the construction technology of blasting control in the mudstone sandstone strata and shallow buried strata avoids the unreasonable blasting design. According to the verification of actual blasting parameters, the calculation method of blasting parameters and related parameters of the mudstone sandstone strata is provided, which provides a reference for the setting of the allowable parameters of the seismic wave. This paper analyzes the common problems of excavation and construction of mudstone sandstone strata and shallow burial strata, and puts forward reasonable measures to help the project make a reasonable construction plan ahead of time, avoid the occurrence of oil pipeline leakage and explosion, thus greatly reducing the construction cost and adverse effects on the local environment.
关键词: 石油管道;地震波速;衰减规律;控制爆破
Key words: oil pipeline;seismic wave velocity;attenuation law;control blasting
中图分类号:U455.4 文献标识码:A 文章编号:1006-4311(2017)21-0099-05
1 工程简况
1.1 位置关系
金家岩隧道1#斜井位于江油市境内,位于线路前进方向的右侧,与线路交点里程DK452+200。该工区施工采用无轨单车道运输组织,永久性工程设计,斜井净空断面尺寸为5.0m×5.9m(宽×高)。金家岩隧道1#斜井下穿兰成渝输油管道,平面投影相交里程为XD1K0+163,1#斜井与输油管道垂直距离为28.42m,?准508兰成渝输油钢管与1#斜井相交纵断面图及平面图如图1、图2。
1.2 地质描述
1#斜井與兰成渝输油管道交叉点,上覆<1-42>6m厚粉质粘土,呈褐黄、紫红色,含少量砂泥岩,中间层为<5-10>W3强风化泥岩夹砂岩,厚度4.1m,质软,属Ⅳ级软石,最底层为<5-10>W2弱风化泥岩夹砂岩。斜井进口为强风化岩石,穿越段区域以泥岩夹砂岩为主,弱风化,岩体较完整,地表水较发育,基岩裂隙水较少。
2 施工方案选择
2.1 常规钻爆施工
由于1#斜井洞顶开挖轴线与在役管线的最小距离为28.42m, 1#斜井爆破施工时必然会对在役输油管道及管道周围环境造成扰动,可能出现的安全隐患归纳为以下几点:
……p>
