注射成型工艺条件对聚丙烯制品光泽度的影响
2011-11-04刘西文杨中文
刘西文,杨中文
注射成型工艺条件对聚丙烯制品光泽度的影响
刘西文,杨中文
(湖南科技职业学院轻化工程学院,湖南长沙410118)
通过一次因子法确定了 Taguchi法的试验因子,采用 Taguchi法对试验因子进行权重分析与优化,并进一步研究了注射成型工艺条件对聚丙烯制品光泽度的影响。结果表明,在注射成型过程中,提高熔体温度、模具温度、保压压力及注射速率都有助于提高制品的光泽度,同时也会提高制品的拉伸强度和弯曲强度,但会降低缺口冲击强度。影响聚丙烯制品光泽度的最显著因素是熔体温度。影响因子的权重大小顺序为:熔体温度、模具温度、保压压力、注射速率。
聚丙烯;光泽度;Taguchi法;注射成型;制品;熔体温度;模具温度
Abstract:In order to explore the effect of injection molding parameters on the glossiness of polypropylene parts,Taguchi method was employed to determine the experiment factors and their weighs.It was found that the increase of melt temperature,mold temperature,dwell pressure,and injection rate could increase the glossiness of the parts;meanwhile the tensile and bending strengths would also increase at the cost of notch impact strength.The descending order in weigh of the influence factors was melt temperature,mold temperature,packing pressure,and injection rate.
Key words:polypropylene;glossiness;Taguchi method;injection molding;part;melt temperature;mold temperature
0 前言
聚丙烯(PP)由于性价比高且加工性能好,已被广泛应用于家用电器、汽车、通讯和医疗等领域。随着PP应用领域的不断增大,对其产品的结构、品质、功能的要求也不断提高,在保证产品的结构、强度和精度的要求下,还要注重制品的外观,特别是表面光泽度,在家用电器、通讯、汽车领域的应用中已引起了人们的高度重视[1]。高光泽制品的生产必须具备3个条件,即高光泽材料、高光模具和合适的工艺控制条件[2]。目前,国内外对于高光泽 PP材料的研究进行了大量的工作,涌现出了多种类型的高光泽PP专用料。在高光模的制造方面目前技术水平也比较高。但由于成型过程的工艺控制因素比较复杂,因此它始终制约着高光泽制品的生产。……
