3%水泥剂量稳定粒料基层的可行性研究
2020-05-28孙华谢秀萍孙建国
孙华 谢秀萍 孙建国



摘 要:为降低沥青路面反射裂缝的发生,减少水泥用量,降低成本,达到节能减排的目的,当基层采用水泥稳定粒料结构时,水泥剂量可直接采用国家规范规定的极限最小值3%,而无需采用常规的5%。本文通过实验获取相关的数据,论证当沥青路面的稳定层设计为水泥稳定粒料结构时,水泥剂量设计为3%,通过适当调整混合料配合比后,其基层的强度和稳定性完全能满足国家规范的要求,并给出水泥剂量为3%时的最佳含水量、最大干密度和最佳配合比。
关键词:水泥剂量;基层;抗压强度;配合比
Abstract:In order to reduce the occurrence of reflection crack of asphalt pavement, reduce the amount of cement, reduce the cost, and achieve energy saving and emission reduction, when the base adopts cement to stabilize the granule structure, the dosage of cement can directly adopt the limit minimum value set by the national code of 3%, instead of the conventional 5%. This paper obtained the relevant data through the experiment, and demonstrated that when asphalt roadbed stability layer was designed as cement stabilized aggregate structure, the cement dosage was designed to be 3%. Through adjusting the mixture ratio of mixture, the grass-roots strength and stability can completely meet the requirements of national standard. The optimum water content, maximum dry density and optimum mixture ratio were given when the cement dosage was 3%.
Keywords:Cement dose; grass-roots level; compressive strength; mixture ratio
0 引言
沥青路面在力学性能上属于柔性路面,该种路面对基层的要求是强度要高、稳定性要好。按中华人民共和国行业推荐性标准《公路路面基层施工技术细则》(JTG/TF 20—2015)的规定,当基层采用水泥稳定式结构时,水泥的剂量应设计为3%~6%,这样才能确保基层具有足够的强度和稳定性[1]。试验表明,稳定层中的水泥含量越高,其强度越大[2-4]。为确保满足规范要求,通常将水泥剂量均设计为5%。在实践中发现,水泥含量大的稳定层通常容易出现开裂现象,此开裂是导致反射裂缝的最直接因素[5-6]。因此,降低稳定层中的水泥含量可减少反射裂缝发生[7-10]。实际上水泥稳定结构有3种:水泥稳定细粒土、水泥稳定粒料土、水泥稳定粒料。不同的材料所采用的水泥剂量不同,本文将通过实验论证当采用水泥稳定粒料结构时,添加3%的水泥剂量就足以达到规范对基层强度和稳定性的要求,且可减少水泥用量,降低工程成本,达到节能减排之效。……
