长方体胶凝原油在热水中的融化实验
2016-07-10刘晓燕崔晓琳王露等
刘晓燕 崔晓琳 王露 等


摘 要: 研究胶凝原油融化特性对原油集输及停输再启动等过程具有重要的意义。对初始温度为10 ℃,尺寸为30 mm ×30 mm×10 mm原油试件在52.5、60、72.5 ℃三种不同水温中进行融化实验,并用红外热像仪记录原油融化过程随时间的变化情况,分析水温对融化时间、原油表面中心点温度以及原油形状的影响。实验结果表明,胶凝原油上表面中心点温度随时间先缓慢升高,后迅速增加,最后变缓并逐渐趋于水温;实验条件下原油融化时间分别为690、300 和220 s;融化过程中原油上表面形状从方形逐渐变为圆形。
关 键 词:胶凝原油;长方体;融化实验;红外热像仪;温度
中图分类号:TE 624 文献标识码: A 文章编号: 1671-0460(2016)03-0532-03
Abstract: The investigation of melting characteristics of the gelled crude oil is of great importance for both gathering and transferring process and shutdown and restarting process. The initial temperature of crude oil is 10 ℃ and the size is 30 mm×30 mm×10 mm. There are three groups of experiments with temperatures of water are 52.5, 60 and 72.5 ℃, respectively. The thermal infrared imager is used to record the changes of oil melting process with time. The purpose of this paper is to analyze the influence of water temperature on total melting time, the center temperature on the surface of gelled crude oil, and the shape of crude oil. The results show that the center temperature on the surface of gelled crude oil raises slowly first and then increases rapidly, and finally tends to the water temperature. The melting time of crude oil under this condition is 690, 300 and 220 s, respectively. The surface shape of crude oil changes from square to circle in melting process.
Key words: Gelled crude oil; Cuboid; Melting experiment; Thermal infrared imager; Temperature
当油温低于含蜡原油的析蜡点后,蜡晶析出,在一定的蜡晶析出浓度下,蜡晶之间彼此交联形成网格结构。随着油温继续降低,胶凝结构的强度不断增大,从而使原油整体上失去流动性。强度过大的胶凝结构很可能导致凝管事故的发生,影响管道的安全运行。为了保证原油正常集输,早期油田普遍采用掺热水或伴热保温输送的集输工艺。然而,课题组的现场试验发现,当原油产出液温度远低于原油凝点时,即使掺入高温水仍不能很快融化,存在凝油严重堵塞集输管道的现象,造成集输困难。为保证油田安全生产,对胶凝原油融化过程进行研究具有重要的应用价值。
关于融化问题,目前的研究主要体现在冰雪融化、金属融化、蓄能复合相变材料、石蜡及各种油产品等领域。……
