精梳机分离罗拉传动机构的平衡研究
2016-01-20李留涛,任家智,贾国欣
精梳机分离罗拉传动机构的平衡研究
李留涛1, 任家智1, 贾国欣2
(1.中原工学院; 2.河南工程学院, 郑州 450007)
摘要:使用质量—加速度法以及机构动力学分析方法,在原有精梳机分离罗拉传动机构数学建模的基础上,运用Solidworks三维建模技术、Adams虚拟样机仿真技术和Matlab计算机编程技术对精梳机分离罗拉传动机构的振动进行研究,探讨了该机构在运动过程中单个构件惯性力的变化规律以及在机构总惯性力中所占的比重,并比较了机构在优化前后惯性力的变化情况。研究表明:对分离罗拉传动机构的平衡优化,可以使机构的振动降低27%以上,有利于提高精梳机的速度和降低能源的消耗。
关键词:分离罗拉传动机构;振动;惯性力;平衡优化
中图分类号:TS112.2
文献标志码:A
DOI:10.3969/j.issn.1671-6906.2015.03.006
Abstract:Using the method of quality-acceleration and dynamics analysis, based on the modeling analysis of the existing detaching roller transmission mechanism of comber, the Solidworks 3 d modeling technology, Adams virtual prototype technology and MATLAB computer programming technology were used in studying detaching roller transmission mechanism of combing machine, the individual components of inertial force and the proportion in the total inertia force of the mechanism were discussed, and the changes of the institutions in the inertial force were compared before and after optimizing. The research results show: the balance optimization of detaching roller transmission mechanism can reduce the vibration of the institutions and more than 27% vibration is reduced, and improve the speed of combing machine and reduce the consumption of energy.
收稿日期:2014-12-11
基金项目:纺织工业协会科技指导性项目(2012024)
作者简介:李铬(1960-),男,河南内黄人,教授。
文章编号:1671-6906(2015)03-0034-03
为完成精梳棉网的搭接及输出,精梳机的分离罗拉必须实现周期性“倒转→顺转→基本静止”的运动,因此,精梳机的分离罗拉传动机构大多采用了将平面连杆机构与差动轮系结合的传动形式,其中平面连杆机构为变速传动部分,差动轮系为恒速传动部分,二者的运动经过合成之后最终传递给分离罗拉,使分离罗拉做周期性“倒转→顺转→基本静止”的运动。
在平面连杆机构中,由于构件的数量较多,多数构件呈不规则形状且为非匀速运动,故在机构运动过程中产生了较大的振动,加剧了构件的磨损,缩短了相关构件的使用寿命,阻碍了精梳机速度的提高。……
