计及终端可靠性的配电终端优化布局方法
2025-08-06卢丹张琳娟邱超郝建国李成
摘 要:配电终端失效将影响配电网故障定位和故障隔离,所以在配电终端规划中不考虑终端失效带来的影响是与实际不符的。为此提出了计及终端可靠性的配电终端优化布局方法,该方法在考虑配电终端故障率和已安装终端与待选安装位置关联关系的基础上,计算馈线各分段的终端安装重要度,然后参照终端安装重要度进行配电终端的优化布局。将该方法应用于RBTS BUS2系统,仿真结果验证了该方法的有效性和寻优效率上的优越性。
关键词:配电终端;优化布局;终端安装重要度;可靠性评估
中图分类号:TM76 文献标识码:A
Optimal Placement of Distribution Terminal Considering
Influence of Terminal Reliability
LU Dan1, Zhang Linjuan1, QIU Chao1, Hao Jianguo1,Li Cheng2
(1.State Grid Henan Economic Research Institute, Zhengzhou,Henan450052, China;
2.College of Electrical and Information Engineering, Hunan University, Changsha, Hunan 410082, China)
Abstract:Distribution terminal failure will affect the power supply reliability of distribution network, so it is inconsistent with the reality that the impact of terminal failure is not considered in the optimal layout of distribution terminal. Therefore, a distribution terminal optimization layout method considering the terminal failure rate is proposed. Based on the consideration of the distribution terminal failure rate, this method calculates the installation importance of each node terminal of the distribution network according to the improvement of power supply reliability by installing the distribution terminal, and considers the influence of the installed terminal nodes on the installation importance of the remaining node terminals. Finally, the node installation importance is used to plan the terminal optimization layout. The proposed method are used to optimize the layout of terminal on RBTS BUS2 system, the layout results verify the effectiveness and superiority of this method.
Key words:distribution terminal; optimization layout model; terminal installation importance; reliability evaluation
配电网故障时,配电终端可辅助快速隔离故障,减少用户停电时间,从而提高供电可靠性。随着我国配电自动化建设和改造的推进,为达到国家电网公司发布的《配电自动化规划设计技术导则》[1]配电自动化有效覆盖率指标要求,各地市的配电网部署了大量的配电终端,出于片面对供电可靠性的追求,造成了三遥终端过度部署,投资效益降低,同时由于终端自身故障或通信原因造成已建成项目的终端在线率并不理想,对供电可靠性的改善不如规划预期。
配电终端优化布局是在满足供电可靠性等技术指标约束的前提下,对配电终端安装数量及布局的策略进行寻优,从而实现最优的经济效益。针对配电自动化终端优化布局问题,目前国内外学者已经进行了一系列研究。文献[2]在假设负荷均匀的前提下,从供电可靠性及投入产出比的角度分析需要安装三遥、二遥终端的数量。……
