低泄漏率可拆密封连接结构设计与试验研究
2021-11-28李亭黄栋渠汪静李东铭郑焕
李亭 黄栋渠 汪静 李东铭 郑焕



[摘 要]密封性能是评价压力容器产品安全性和经济性的重要技术指标。传统的压力容器设计规范通常要求根据公称压力、工作温度和介质选用密封结构,但并没有给出定量评价密封结构泄漏率的方法。对某压力容器低泄漏率要求开展了可拆密封连接结构的选型设计与试验研究,实现高温、强腐蚀、低泄漏率可拆密封连接,泄漏率不大于1×10-7 Pa·m3/s;分析了影响结构密封性能的主要因素并从结构设计和加工制造方面提出了建议。
[关键词]密封性能;泄漏率;压力容器
[中图分类号]TH49 [文献标志码]A [文章编号]2095–6487(2021)08–0–02
[Abstract]Sealing performance is an important technical index to evaluate the safety and economy of pressure vessel products. Traditional design code of pressure vessel usually requires sealing structure according to nominal pressure, working temperature and medium, but no quantitative evaluation method is given. This paper has carried out the selection design and test research of the detachable sealing connection structure for the low leakage rate requirement of a pressure vessel. The high temperature, strong corrosion and low leakage rate detachable sealing connection are realized, and the leakage rate is no more than1×10-7Pa·m3/s; The main factors that affect the sealing performance of the structure are analyzed and suggestions are put forward from the aspects of structure design and manufacturing.
[Keywords]sealing performance; leakage rate; pressure vessel
密封性能是评价压力容器产品安全性和经济性的重要技术指标。随着现代工业特别是核能工业的兴起,压力容器密封向着高温、高压、强腐蚀和低泄漏率方向发展。传统的压力容器设计规范如《GB150.1~GB150.4—2011压力容器》[1]《HG/T20583—2011钢制化工容器结构设计规定》[2]通常要求的根据公称压力、工作温度和介质选用密封结构,但并没有给出定量评价密封结构泄漏率的方法;对于常规压力容器仅对压力试验做出了明确规定,泄漏试验要求则由设计单位自行确定。参考《法兰用密封垫片实用手册》[3],常规密封元件如缠绕垫、金属齿形组合垫密封泄漏率通常在10-3 ~10-5 Pa·m3/s量级。某核能项目压力容器要求可拆密封连接泄漏率不大于1×10-7 Pa·m3/s,按常规设计方法显然难以满足此要求。为此本文开展了低泄漏率可拆密封连接结构的选型设计与试验研究,为同类产品密封结构设计提供参考。……
