Corrigendum to “Modifie embedded-atom method interatomic potentials for Mg-Al-Ca and Mg-Al-Zn ternary systems”. [J. Magnes. Alloy. 9(2021) 317-335]
2021-04-09HyoSunJangDonghyukSeolByeongJooLee
Hyo-Sun Jang, Donghyuk Seol, Byeong-Joo Lee
Department of Materials Science and Engineering, Pohang University of Science and Technology (POSTECH), Pohang 37673, Republic of Korea
Available online 31 March 2021
The authors regret that the printed version of the above article contained several errata that were not recognized until publication. The errata were corrected as follows.
(1) The firs sentence of the last paragraph in the section Formalism and determination of interatomic potential parameters on p. 321 should read, “Due to the good applicability, this assumption was applied to develop the Mg-Al-Ca and Mg-Al-Zn potentials, assuming that Mg and Ca located in the same group of the periodic table are relatively similar to each other compared to Al located in another group, and that Mg and Zn with an hcp structure are relatively similar to each other compared to Al with an fcc structure, respectively.”
(2) The Ecvalue of the Al-Zn system in Table 3 should read “2.7625 (0.75EcAl+0.25EcZn-0.03).”
(3) The Supplementary Information LAMMPS parameters should be replaced with the attached file
The authors would like to apologize for any inconvenience caused.
Supplementary materials
Supplementary material associated with this article can be found, in the online version, at doi:10.1016/j.jma.2021.03.001.
杂志排行
Journal of Magnesium and Alloys的其它文章
- Mechanism of Mn on inhibiting Fe-caused magnesium corrosion
- Investigating TiO2-HA-PCL hybrid coating as an efficien corrosion resistant barrier of ZM21 Mg alloy✩
- Effect of yttrium modificatio on the corrosion behavior of AZ63 magnesium alloy in sodium chloride solution
- Effect of lithium content on the mechanical and corrosion behaviors of HCP binary Mg-Li alloys
- Poly caprolactone/titanium dioxide nanofibe coating on AM50 alloy for biomedical application
- New design principles for the bath towards chromate- and crack-free conversion coatings on magnesium alloys
