孔板流量仪表研究现状及改进分析
2020-12-24王利东
王利东
摘 要:孔板流量计是工业生产中最常用的计量仪表之一。文章阐述了孔板流量仪表设备的计量原理;从孔板节流装置、二次测量仪表和信号引线方面介绍了目前孔板流量仪表的组成和结构;分析了现有孔板流量仪表设备的优缺点和安装要点。从孔板流量仪表的整体误差、安装管理误差和运行工况下的误差分析了影响计量精度的因素。最后提出了孔板流量仪表设备的改进建议。
关键词:孔板流量仪表;计量方式;计量特点
中图分类号:TE863.1 文献标志码:A 文章编号:2095-2945(2020)26-0102-02
Abstract: Orifice flowmeter is one of the most commonly used measuring instruments in industrial production. In this paper, the measuring principle of the orifice flow meter is described; the composition and structure of the orifice flow meter are introduced from the orifice throttling device, secondary measuring instrument and signal lead; the advantages and disadvantages and installation points of the orifice flow meter are analyzed; the factors that affect the measurement accuracy are analyzed from the overall errors, installation management errors and errors under operating conditions. Finally, the improvement suggestions of the orifice flow meter equipment are put forward.
Keywords: orifice flowmeter; measurement method; measurement characteristics
1 孔板流量儀表的计量原理
当流体流经孔板流量仪表设备的孔板时,横截面积减小,速度增加,相应的压强减小,并且减小的程度与流动状态的流体速度成正比。所以可以通过检测压差来推算流速,进而计算出流量。孔板前后的压差与流量Q具有以下关系:
式中:C-流出系数;d-开孔直径;ε-可膨胀性系数;β-直径比。
2 孔板流量仪表设备的组成
孔板流量仪表设备系统一般包括流量仪表设备本体、二次仪表和流体组分分析系统,其中的流体组分分析系统具有检测、计算、分析和积算等功能。国家制定了相关标准以利于保证流量计量检测的准确性。
2.1 孔板节流装置
孔板用以产生压差,开孔尺寸必须严格按照规定,是孔板节流装置中最重要的结构,还有负责固定孔板位置的孔板加持器和上下游直管段;此外,还需要配置引压管、对焊法兰和直通式截止阀。只有孔板节流装置完全符合行业标准,才可以满足用户的使用要求,保证信号的准确。……
