不同钠盐改性蒙脱土的制备及表征
2020-08-25王品王海娟牛国庆
王品 王海娟 牛国庆



摘 要:为了后期制备有机改性蒙脱土,利用离子交换法将氯化钠、硫酸钠和碳酸钠三种钠盐表面活性剂插入到天然蒙脱土(MMT)层间,对其进行钠基化处理,并对改性后的蒙脱土结构和性能进行了表征。热重分析(TGA)结果表明,钠盐已成功插层到蒙脱土层间,改性后的蒙脱土热稳定性增强;X-射线衍射分析(XRD)结果表明,改性后的蒙脱土层间距增大,平均层间距分别从0.99 nm增大到1.25、1.23、1.21 nm,其中氯化钠改性效果最好。
关 键 词:蒙脱土;钠盐;无机改性;制备;表征
中图分类号:TB 34 文献标识码: A 文章编号: 1671-0460(2020)05-0773-04
Abstract: In order to prepare organic modified montmorillonite(MMT), three kinds of sodium surfactants of sodium chloride, sodium sulfate and sodium carbonate were inserted into the layers of natural montmorillonite by ion-exchange method. Sodium radical treatment of modified montmorillonite was carriedout,and the structure and performance were characterized. Thermogravimetric analysis (TGA) results showed that sodium salt was successfully inserted into the montmorillonite, and the thermal stability of the modified montmorillonite was enhanced. The results of X-ray diffraction (XRD) analysis showed that the layer spacing of the modified montmorillonite increased from 0.99 nm to 1.25, 1.23, 1.21 nm, respectively, and sodium chloride had the best modification effect.
Key words: Montmorillonite; Sodium salt; Inorganic modification; Preparation; Characterization
蒙脱土(montmorillonite,MMT)又名胶岭石、微晶高岭石,是一种2∶1型层状结构含水硅酸盐矿物,结构式为(Al, Mg)2〔SiO10〕(OH)2·n H2O。蒙脱土的结构片层是由上下两片T层和中间一片O层组成,T层为Si-O四面体,O层为Al-O四面体,三个片层之间的连接方式为共价键,每个结构单元厚度为1 nm左右,如图1所示[1]。由于铝氧八面体中的价位较高的铝原子易被低价原子取代,使得片层间带有一定的负电荷,为保持层间结构的稳定性,会吸收周围的Na+、Ca2+、Mg2+、Al3+、K+等阳离子[2-4],具有很强的吸附能力和阳离子交换性能,可用做漂白剂、吸附剂、填充剂和阻燃剂等。
我国的蒙脱土矿物资源十分丰富,但自然界产出的蒙脱土绝大部分为Ca基蒙脱土,性能较差[5],而Na基蒙脱土的阳离子交换能力较强,在水中的膨胀性及分散性好,因此在制备复合材料时,主要选用Na基蒙脱土[6]。另外,由于蒙脱土表面的亲水疏油性,导致其与单体和聚合物的相容性差,因此对蒙脱土进行改性处理使其表面呈疏水性[7-9],可以提高其使用性能并扩大应用领域[10]。……
