轻卡车前风窗玻璃装配质量影响因素分析
2020-05-03张春艳李蕴泽陈文波
张春艳 李蕴泽 陈文波


摘 要:汽车白车身前风窗由前围焊接总成、左右侧围总成、顶盖焊接总成、前顶横梁等多个零部件搭接、拼焊而成。它组成复杂,所以尺寸容易出现问题。文章对一款轻卡车前风窗玻璃装配困难的现象展开分析,通过三坐标检测数据、前风窗检具复检等进行综合对比,确定质量改善方向。最终把前风窗开口尺寸控制在公差范围内,满足装配要求,从而改善了整车质量。
关键词:前风窗;装配困难;夹具
Abstract: The front window of the body-in-white of a car is made by overlapping and welding multiple components such as a firewall welding assembly, body side L/R assembly, a roof welding assembly, and a front roof beam. Its composition is complicated, so the problem of size is easy to occur. This article analyzes the difficult assembly of the front windshield glass of a light truck. Through comprehensive comparison of three-dimensional inspection data, re-inspection of the front windshield inspection fixture, etc., the quality improvement direction is determined. Finally, the size of the front window opening is controlled within the tolerance range to meet the assembly requirements, thereby improving the quality of the vehicle.
前言
某轻卡车型白车身生产线自动化水平很高。尤其主下线,达到90%左右。在商用车领域属于行业中高端水平,生产一致性很高。在这样的高自动化率的白车身生产线上生产的轻卡车,被总装车间反馈前风窗玻璃装配困难。出现了装配不到位、需要用橡胶榔头敲击的情况,并且敲击过程中有前风窗玻璃破损的现象。针对这种情况,进行了相关分析。
1 前风窗玻璃安装困难的原因分析
依据当前生产状态,从生产源头入手,对人、机、料、法、环等多方因素进行分析并讨论。具体如下:
1.1 人的因素
在前风窗合拼成型过程中,侧围和前围在主拼工位由主拼夹具定位后,顶盖通过机器人抓取上件。在这一过程中,人为干涉较少,不会影响生产的一致性和车身精度。所以,判定人的因素排除。
1.2 法的因素:法,即工艺方法
在白车身制造过程当中,可以用到两种工艺方法。一是针对产品数据工艺。产品数据是工艺生产的根本。在本案中,前风窗X向开口的理论尺寸是762.6mm±1.5mm。……
