某轻型载货车车架轻量化分析
2020-02-25钱玉兰
钱玉兰
摘 要:根据项目组的要求,对某轻型载货车车架进行轻量化验证分析。文章基于有限元法,运用Hypermesh、Nastran等有限元计算分析软件,建立车架有限元模型,对车架进行模态及扭转模量分析,在垂向弯曲工况、紧急转弯工况、过坑扭转工况、紧急制动工况四种恶劣工况模式下对车架进行强度校核分析,通过对优化前后分案的分析对比,优化后方案的模态、扭转模量与优化前相当,强度方面优于优化前方案。分析结果表明,新方案模型可以替代原方案模型,轻量化设计成功减重27Kg,约为优化前质量的9.7%。关键词:载货车;车架;轻量化;有限元分析中图分类号:U467 文献标识码:B 文章编号:1671-7988(2020)01-77-03
Abstract: According to the requirements of the project team, the lightweight analysis of a light truck frame is carried out. Based on the finite element method, the finite element model of the frame is established by using the finite element calculation and analysis software Hypermesh and Nastran. The modal and torsional modulus of the frame are analyzed. The strength of the frame is checked under the vertical bending condition, the emergency turning condition, the pit-crossing torsion condition and the emergency braking condition. The analysis shows that the mode and torsion modulus of the optimized scheme are comparable to those of the pre-optimized scheme, and the strength of the optimized scheme is better than that of the pre-optimized scheme. The analysis results show that the new scheme model can replace the original scheme model. The weight loss of the lightweight design is 27Kg, which is about 9.7% of the pre-optimization quality.Keywords: Truck; Frame; lightweight; FEACLC NO.: U467 Document Code: B Article ID: 1671-7988(2020)01-77-03
前言
对于卡车而言,车架是汽车的载体,承载着动力系统、 驾驶室、传动系统、转向系统、上装载货物等。在保证其强度和刚度需求的基础上,降低车架总成的重量,不仅可以减少材料用量降低成本,同时可以提高用户收益,创造经济价值。商用车车架均为钢材,占整车质量比重较大,传统设计为保证承载能力,过于保守导致重量过大[1-2]。
本文以某載货车车架为例,根据项目组的轻量化要求,对车架进行轻量化优化分析,通过有限元软件,对模型进行离散,建立有限元模型,考察优化后模型的模态刚度,并考察垂向工况、转弯工况、扭转工况制动工况下其性能是否满足要求。通过分析,优化后的车架减重明显,且各方面性能都能满足使用要求,达到项目组轻量化目标。
1 车架有限元建模……p>
