基于Cruise的电动汽车匹配CVT变速器仿真分析
2020-02-25唐丽萍吕掌权
唐丽萍 吕掌权
摘 要:目前,固定速比减速器结构简单、成本较低,在电动汽车上得到了广泛的应用。但是,该结构形式对电机的转速和转矩特性有较高的要求,而且增加了电机在低效率范围工作的概率,而无级变速器在一定范围内可以连续变化,实现电机的高效运转。因此本文针对某款电动车,分别匹配固定速比减速器和CVT无级变速器进行仿真分析。结果表明,在NEDC循环工况下,匹配CVT无级变速器的电动汽车在动力性方面明显增强,但经济性有所减低。关键词:CRUISE;纯电动汽车;CVT中图分类号:U469.7 文献标识码:B 文章编号:1671-7988(2020)01-06-03
Abstract: At present, the fixed speed ratio reducer has been widely used in electric vehicles due to its simple structure and low cost. However, this structure has higher requirements on the speed and torque characteristics of the motor, and increases the probability of the motor operating in the low efficiency range. The CVT can be continuously changed in a certain range to achieve efficient motor operation. Therefore, in this paper, a fixed speed ratio reducer and CVT stepless transmission are respectively matched for simulation analysis of a certain electric vehicle. The simulation results show that, under NEDC cycle condition, the electric vehicle matched with CVT transmission has obvious enhancement in power performance, but the economy is reduced to some extent.Keywords: CRUISE; Electric Vehicle; CVTCLC NO.: U469.7 Document Code: B Article ID: 1671-7988(2020)01-06-03
前言
随着国家政策的大力支持,我国电动汽车行业得到了快速发展,2018年中国电动汽车产销量突破200万辆,但是现阶段电动汽车续航里程、能耗问题一直是汽车厂商亟待解决的问题,对电动汽车传动系统进行合理的结构设计及参数匹配能够提高电动汽车的性[1]。目前,绝大部分汽车使用固定传动比减速器,该传动方式,结构简单,成本低。但是采用固定速比减速器,对电机的转速及转矩特性要求较高,电机效率相对较低[2]。而搭载CVT无级变速器能够充分发挥电机性能,提高电机在低转速时的扭矩和高转速下的功率,增大电机在高效率范围工作的概率[3]。
在电动汽车多挡化的方面,国内外有很多相关研究,但是多数采用两挡式变速器,能在一定程度上提高整车的经济性及动力性,但是对搭载CVT变速器的研究较少[4-6]。本文针对某电动汽……
