APP下载

水解酸化—缺氧—好氧联合工艺处理某工业园区废水

2018-05-10王文娜

环境与发展 2018年3期

摘要:本文预处理工艺采用“调节池+絮凝沉淀”,稳定进水水质、水量的同时去除可能带入的悬浮物。生化工艺采用“水解酸化+缺氧+好氧”联合工艺,生化段采用了复合生物滤池工艺,具有抗冲击负荷能力高、污泥不易流失、处理效率高等优点。并在池型上进行了改良,保证了进水及出水的均匀性,提高了处理效果。深度处理部分采用了“臭氧+微絮凝过滤”工艺,同时在施工图设计时在平面布局及管道设计时考虑臭氧可放到生化段前面,以防止水质变化时可以灵活应对。本工程经过一个月的实际运行,出水完全可达到《城镇污染物排放标准》一级A标准,同时工艺稳定、可靠、高效,为同类化工园区工业废水提供借鉴作用。

关键词:合成氨;生物滤池;废水处理

中图分类号:X703 文献标识码:A 文章编号:2095-672X(2018)03-0130-02

DOI:10.16647/j.cnki.cn15-1369/X.2018.03.075

Abstract: In this paper, the pretreatment process uses “regulating tank + flocculation sedimentation” to stabilize the influent water quality and water volume and remove the suspended solids that may be brought into the process. Biochemical process using “hydrolytic acidification + hypoxia + aerobic” combined process, the biochemical section of this composite biofilter technology, with high impact load capacity, sludge loss is not easy to deal with the advantages of high efficiency, and in the pool type Improved, to ensure the uniformity of water and water, improve the treatment effect. Depth treatment part of the “ozone + micro-flocculation filter” process, at the same time in the construction design in the layout and pipeline design considerations ozone can be put in front of the biochemical section, in order to prevent water quality changes can be flexible. After a months actual operation, the effluent can reach Grade A standard of “urban pollutant discharge standard” completely, meanwhile the process is stable, reliable and efficient, which can provide reference for industrial wastewater in similar chemical industrial parks.

Keywords: Synthetic ammonia; Biological filter;Wastewater treatment

1 進出水水质确定

1.1 进水水质

经过两个月的调研,确定的进水水质如下:

1.2 出水水质

工业园污水处理厂(一期)出水水质需按《城镇污水处理厂污染物排放标准》(GB18918-2002)中一级标准中的A级标准执行。

2 污水处理厂处理规模及水质

经调研,污水处理厂处理规模确定为30000m3/d。

3 水质分析及工艺流程选择

(1)预处理工艺段选择。经过调研,该工业园区生产企业以棉浆粕生产、电解铝及合成氨生产为主,棉浆粕废水的特点为悬浮物浓度高、难生化、色度高[1],电解铝废水主要以石油类、悬浮物等污染物为主[2],合成氨废水主要以氨氮及总氮为主。

(2)生化工艺段选择。工业园区污水处理厂来水特点之一为难以生化,所以生化段工艺采用了水解酸化+缺氧+好氧的联合工艺。……

登录APP查看全文