变压器局部放电信号检测与类型识别
2016-05-14赵建利刘海峰刘婷岳国良孙祎付龙明
赵建利 刘海峰 刘婷 岳国良 孙祎 付龙明



摘 要: 为实现变压器局部放电信号检测和类型识别,设计基于超高频(UHF)法的变压器局部放电检测系统,针对4种典型的变压器放电模型进行了局部放电实验,获得相应的局部放电包络信号数据,并通过以太网通信将数据上传至电脑。利用提升双树复小波变换对包络信号数据进行消噪,从消噪后的信号不难看出,同一放电模型的局部放电包络信号形状大致相同,不同放电模型存在差别。提取6种包络信号的特征参数,结合外部加载电压,采用BP 神经网络对变压器局部放电类型进行识别,当训练误差δ=0.02时,变压器放电类型识别平均正确率在98%以上。
关键词: 变压器局部放电; 超高频法; 提升双树复小波; BP神经网络
中图分类号: TN911.23?34; TM933 文献标识码: A 文章编号: 1004?373X(2016)06?0166?05
Signal detection and type recognition of transformer partial discharge
ZHAO Jianli1, LIU Haifeng2, LIU Ting1, YUE Guoliang2, SUN Yi1, FU Longming3
(1. Electric Power Research Institute, State Grid Hebei Electric Power Company, Shijiazhuang 050021, China;
2. State Grid Hebei Electric Power Company, Shijiazhuang 050021, China;
3. Beijing Joinbright Digital Power Technology Limited Company, Beijing 100085, China)
Abstract: A transformer partial discharge detection system based on ultra?high frequency (UHF) method was designed to realize the signal detection and type recognition of transformer partial discharge. The partial discharge experiments were conducted for the four typical transformer discharge models to obtain the corresponding envelope signal data of partial discharge. The data is uploaded to the computer through Ethernet communication. The envelop signal data was denoised by improving the dual?tree complex wavelet transform. It is not difficult to find from the denoised single that the envelop signal shapes of the same partial discharge model are almost the same, and the envelop signal shapes of different partial discharge models are different. The transformer partial discharge types were recognized with BP neural network, by extraction of characteristic parameters of six envelop signals, and in combination with the external loading voltage. When the training error δ is 0.002, the average correctness of transformer discharge type recognition can reach up to more than 98%.
Keywords: transformer partial discharge; UHF method; improvement of dual?tree complex wavelet; BP neural network
变压器是电力系统中的关键设备,维护其安全稳定运行至关重要。变压器运行的可靠性取决于其绝缘状况,变压器在绝缘性能降低时会产生局部放电,而局部放电又会导致变压器绝缘性能进一步下降甚至破坏,因此,检测变压器局部放电具有很高的应用价值[1?2]。
变压器局部放电产生的UHF 信号包含了放电类型、放电强度以及局部放电源位置等丰富的信息[3?6],但UHF 信号频谱带宽高达GHz,如何得到该信号是个非常棘手的问题。采用数据采集装置直接对UHF 原始信号进行采样, 数据量巨大,硬件电路成本十分昂贵;而采用频谱仪对UHF 信号实施频谱分析的方法也仅用于实验室研究。……
