220 kV轴向双分裂绕组变压器半穿越阻抗的数值仿真和分析
2015-05-11王寅炜田颢亮庄百兴
王寅炜 田颢亮 庄百兴



摘要:针对在轴向分裂绕组变压器设计时其半穿越阻抗较难计算,传统的公式推导方法计算误差较大的问题,介绍2种结合商业有限元软件的计算方法,一种利用最小能量原理计算,另一种利用场路耦合计算.对某实际产品进行计算,并对计算值与实测值进行比较.结果表明:利用最小能量原理计算得到的结果准确性很高,最大误差为-1.9%,可为产品设计提供参考.
关键词:分裂绕组变压器; 半穿越阻抗; 最小能量; 场路耦合; 电抗; 有限元
中图分类号: TM401.1; TB115.1
文献标志码:B
Abstract:During the design of axial split winding transformer, it is difficult to calculate the semi-crossing impedance and the error of the calculation using the traditional formula derivation method is relatively large. Two calculation methods are introduced, which are both combined with commercial finite element software. The minimum energy theory is used for one method, and the field-circuit coupling calculation is used for another method. The calculation is performed on an actual product and the calculated values are compared with the measured values. The results indicate that the calculated results obtained by minimum energy theory is very accurate with a maximum error of -1.9%, which can provide reference for product design.
Key words:split winding transformer; semi-crossing impedance; minimum energy; field-circuit coupling; reactance; finite element
0引言
分裂绕组变压器具有2路灵活供电、限制短路电流等特点,经常被用作厂用变压器和启备变压器.轴向分裂绕组变压器全穿越运行时与普通双圈电力变压器类似,阻抗计算一般通过公式推导,可较精确地求解,但在半穿越运行时漏磁场分布复杂,公式推导繁琐,特别是在极限分接时很难计算准确.借助有限元计算软件进行计算,可提高计算准确率,有利于提高产品质量和一次成功率.
本文采用商业有限元软件ANSYS Maxwell对SFFZ10-500000/220轴向双分裂绕组变压器进行三维漏磁场和半穿越阻抗的仿真研究,并对计算结果与实测值进行比较分析.
1计算模型建立
1.1计算软件介绍
ANSYS Maxwell是ANSYS公司旗下基于Maxwell方程的低频电磁场仿真分析软件,其可对存在电磁现象的各种产品进行设计和仿真分析,具有功能强大且方便易用的静电场、静磁场、涡流场和瞬态场等求解器,可用以电机、变……
